TEMP-1
Day/ Night Temstat Controls cooling or heating equipment according to a daytime or nighttime set-point. 6 foot cord with temperature sensor precise to 2°F / 1°C. Can power 120Vac equipment up to 15 amp. Typical control differential stands between 4° and 7°F / 2° and 4°C.
TEMP-2
Adjustable differential Tempstat Controls cooling or heating equipment according to a setpoint and an adjustable differential from 4° to 20°F / 2° to 11°C. 6 foot cord with temperature sensor precise to 2°F / 1°C. Can power 120Vac equipment up to 15 amp.
TEMP-3
High temperature shut-off Tempstat Automatically shuts down lighting and/or other equipment when a high temperature setpoint is reached. Once turned-off, the unit will run a user selected delay from 0 to 15 minutes before turning back on (temperature setback of 5° or 10° F / 3° to 5°C). 6 foot cord with temperature sensor precise to 2°F / 1°C. Can power 120Vac equipment up to 15 amp. To be used in conjunction with 120Vac triggered high-load or light switcher like the LS1, LS2 or LS3.
Temp-1V
Day & Night thermostatic fan speed control Automatically slows down or speeds up centrifugal fans to respect user selected temperature day and night setpoints. Enables a much tighter and precise temperature curve. When ON/OFF controls usually yields a variation over 5°F / 3°C, TV1 will yield a variation below 2°F / 1°C. 6 foot cord with temperature sensor precise to 2°F / 1°C. Can drive single phase 120 Vac induction motor type fans up to 750 Watts. Any forced ventilation rooms should be equipped with this type of control to promote faster and more vigorous growth.
